2007). Ab initio methods were used to describe the pigments, while a classical electrostatic method was used to describe the whole www.selleckchem.com/products/riociguat-bay-63-2521.html complex on the atomic level. As a result of the low dielectric constant of water/glycerol below the freezing point, the standard protonation pattern of the amino acids was no longer valid and half of the usually acidic and basic groups turned out to be neutral.

This complex method was simplified, without losing the main results by assuming a standard protonation pattern and by the introduction of an effective dielectric constant for screening effects (Adolphs et al. 2008). There exists an earlier account of similar quantum calculations where, amongst others, the effect of the charged amino acids was included (Gudowksa-Nowak et al. 1990). However, the resulting click here site

energies are spread over a range (∼770–840 nm) much larger than what is observed in spectra, hence, and these results are not used for exciton calculations. While, for some of the earlier calculations and fits, the range of site energies only spans 10 nm, the more recent ones seem to converge to a difference between the highest and lowest site energy of almost 30 nm, which is comparable to the total width of the absorption spectrum. The most widely accepted values of the site energies for Prosthecochloris aestuarii are given by Louwe et al. (see Table 1). Nevertheless, Selleck Vactosertib improvements have been obtained using more and more elaborate models and by calculations of the site energies rather than fitting them. In general, only seven different site energies are included as parameters in PAK6 the fits, however wether or not to include interaction

between the monomers remains controversial. Exit pigment in the FMO complex The pigment with the lowest site energy is the most likely candidate for an exit pigment, which transfers the excitation energy from the FMO complex to the reaction center. The position of this pigment within the FMO complex cannot be detected optically because this would require a resolution below the diffraction limit, and, therefore, it can only be assigned from the outcome of exciton simulations. However, since photosynthesis occurs at 300 K, at room temperature, none of the exciton states should be excluded from, a transition dipole-weighted, energy transfer to the reaction core complex. Table 2 shows the different “exit pigments” that have been proposed, with consensus now leaning toward pigment 3. A detailed account on the nature of the electronic state of the exit pigment will be given in “Nature of the lowest energy band”. Table 2 Lowest site energy of the BChls in the FMO complex from Prosthecochloris aestuarii References Site energy (nm) Pigment number Pearlstein (1992) 826.4 7 Lu and Pearlstein (1993) 822.4 7 Gülen (1996) 815.